Interactive Behavior while Moving Objects This can be disabled by turning off the Snap to Center option in the PCB Editor - General page of the The default behavior is to snap to the object's reference point whenever you click and hold to move an object.
If multiple objects are moved, their position relative to each other is maintained. In this situation, the Move Selection command must be used (unless there is a non-track object in the selection set to click and hold on). A set of selected tracks cannot be moved using the click and hold technique. In fact, it can help to place a temporary pad or via to help with the precise relocation of a set If positioning is critical, it is better to use the Move Selection command described below because you can move the cursorĪround until it snaps to an object reference point, such as the center of a pad, which then becomes the point by which the set of objects is held. Note that this held point may not be an object reference point. When multiple objects are moved using click and hold, the cursor will jump to the nearest grid pointĪnd then begin to move the selection set. A set of selected objects can also be moved using the click and hold technique depending on which kind of object in the selection set is clicked. You can then hold Shift to step in 10 x grid increments. Move the object(s) in single grid increments. The advantage of using a Move command is that arrow keys can be used to accurately Holding the mouse button down is not required if you use a Move menu command. Click and hold requires the mouse button to be held down. For multiple objects, the location where the selection set is held will be on the current snap grid. Single objects are moved on the current snap grid. a vertex for a track or polygonal-shaped object. its reference point for a single reference point object such as a pad, via or component, or. Click and hold the mouse button to move a single object. Ī summary of each is given in the table below. DetailsĪs well as moving objects directly with the mouse, specific movement commands are available by clicking Tools | Arrange |. Refer to the Grids and Units page for more information on setting and working with the Snap Grid. All object movement is constrained to the current Snap Grid.
0 kommentar(er)
